![]() ![]() See "Connecting the Machine", Network and System Settings Guide. If the machine is using wireless LAN, SSID settings are incorrect.Ĭheck using the machine's display panel that the SSID is correctly set. (You can check signal status only when using wireless LAN in the infrastructure mode.) If signal quality is poor, move the machine to a location where radio waves can pass or remove objects that might cause interference. In, under, select, and then press to check signal status. If the machine is using wireless LAN, failure to print might result from a weak wireless signal. The interface cable was connected after the machine was switched on.Ĭonnect the interface cable before turning on the machine. See "Connecting to the Interfaces", Network and System Settings Guide. If the cable is damaged or worn, replace it. The type of interface cable you should use depends on the computer. The correct interface cable is not being used. If it has a fastener, fasten that securely as well. The interface cable is not connected correctly.Ĭonnect the interface cable securely. The cause is displayed on the display of the control panel.Ĭheck the error message or warning status on the display panel and take the required action. ![]() Ĭheck the cable is securely plugged into the power outlet and the machine. This section describes what to do if printing does not start even after performing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |